Heartland Range 7200 User Manual download pdf (Page 10)

Power In

(male receptacle)

Exhaust Hood In

(female receptacle,

from

)

Power In

(male receptacle)

Exhaust Hood In

(female receptacle,

from )

Model 9200

Model 7200

Back of stove

1. When the range is fully assembled, recheck all electrical connections especially between

the exhaust hood and the back of the range. As well, check that all nuts and bolts have been

tightened.

2. Ensure teflon gliders and flooring are clean.

3. Caution: On flooring with very rough surfaces or deep, large grooves the appliance may

have to be lifted and slowly slid into position.

4. Put both hands on the trim and carefully push the range into place. Make sure floor is clear

of all debris. Don’t forget to plug in the main power cord and the exhaust hood power

cable before the range is in its final position. See closet installation instructions.

5. To level the range, simply adjust the levelling screws with teflon pads located at the bottom

of each leg. Using a 5/16” (8 mm) open-end wrench, turn the adjusting screw clockwise to

raise up the corner, and counter-clockwise to lower the corner. (Don’t forget the teflon glider

should extend beyond the bottom of the leg by approximately 1/8”-1/4”.)

6. Note: On soft kitchen flooring, the weight of the stove may cause slight depressions in the

flooring. When the range is in position and levelled, you may want to place coasters under the

teflon gliders of each leg to protect the floor. Remove the coasters when moving the range for

cleaning or servicing.

closet

Positioning the Range

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 80 81

No comments

Heartland Range 7200 User Manual Page 10