Heartland Range 7200 User Manual download pdf (Page 17)

Model 7200

Appliances

How to Steps

Appliance Clearances (see Page 17 for additional details):

• Sides of stove to adjacent surfaces: 1/2” (1.5 cm) min

• Nickel trim to adjacent surfaces: 0” right and left

• Rear clearance: 0”

• Closet right side to cabinets: 0”

• Top of counter to underside adjacent cabinets: 18” (46

cm)

• Cooktop to underside overhead cabinets: 30-1/4” (77

cm)

• Edge of range to combustible wall on either side: 6”

(15 cm)

• Cut out width for range’s main body: 48/1/2” (123 cm)

• Max. countertop depth: 24” (61 cm); height: 36” (91

cm)

• Max. overhead cabinet depth: 13” (33 cm)

Note: If unit is installed beside a refrigerator it is important

that there be at least 5” (13 cm) between the refrigerator

and range for proper air circulation.

Gas

•

• Natural Gas/Propane Conversion kits available from

dealer or factory and must be performed by a licensed

• Pressure requirements: Nat Gas: 5” W.C. (min);

• LP gas: 11” W.C. (min)

•

• Connection: 1/2” NPT

• An accessible manual shut off valve must be installed

at the appliance.

Stove must be installed in compliance with local codes.

In the absence of local codes, with the National Electrical

code ANSI Z223.1 in the US or in Canada with the CSA

Standard B149.1.

Appliances installed in the state of Massachusetts:

• This appliance can only be installed in the state of

Massachusetts by a Massachusetts licensed plumber

• This appliance must be installed with a three (3) foot /

• A “T” handle type manual gas valve must be installed

in the gas supply line to this appliance in an accessible

location.

Electrical

• Electrical hookup must be performed by a licensed

electrician.

• 120 Volts 60Hz .375 Kw.

• 5 ft (1.5 m) power cord included with 3 prong plug.

• Stove must be electrically grounded in compliance with

local codes. In the absence of local codes, with the

National Electrical code ANSI/NFPA 70 “Latest Edition”

in the US or in Canada with the Canadian Electrical

Code, Part I, CSA Standard C22, or the Local National

Electrical Code.

Venting

How to Steps

Option 1 - Ventless installation:

• Requires no further set up

(cooking fumes are drawn

and exhausted through

rear of hood, back into the

room.)

Option 2 - Venting directly outside:

• Method 1 - Installation

through outside wall.

• Method 2 - Installation

through attic to outside

• 3 1/4” x 10” Exhaust adaptor

included with range

Method 1 Method 2

Safety

• Maximum ducting run: 25 linear feet - subtract 5’ per

90 deg elbow and 2.5’ per 45 deg elbow. Do not use

more than two elbows. All duct work must be metal.

Do not use plastic duct. The range hood should never

be exhausted into a wall cavity or an attic where an

• Installation must be completed in accordance with all

local & national codes.

•

storage space above range should be avoided. Existing

cabinets min clearance 30-1/4” (76 cm).

• Use only materials which conform to local codes in

effect.

• Gas cooking appliances produce heat and moisture -

ensure kitchen is well ventilated. Prolonged intensive

use may require additional ventilation (opening

windows or addition of supplementary air exhaust

sources).

closet

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 80 81

Comments to this Manuals

No comments

Heartland Range 7200 User Manual Page 17

Comments to this Manuals

Related products and manuals for Cookers Heartland Range 7200